Do it your self projects
Nont
This user hasn't shared any biographical information
Homepage: http://www.diymaker.com
Posts by Nont
DIY Arduino Ethernet Board
Jul 10th
Feel like Ethernet shield are a bit expensive ? you can done it one by your self. This great work showing on instructables how to DIY Ethernet arduino compatible, completely schematic diagram using Microchip ENC 28J60 with PCB layout.
Wireless Control Airsoft Gun Colors Tracking Robot
Jun 28th
This is my senior years final project, i build the mini tank with M4-Carbine Airsoft gun mounted. It can wireless control RGB color tracking. let see robot specification source code below.
DIY Funny Cups Picker Robot
Jun 27th
Very talent and funny robot can autonomous pick up the cups with fuzzy logic. Using Arduino mega with 360° infrared sensors detection omni wheels with encoders and a lot of more. see his development log at: letmakerobot
Cool Jumper RoBot
Jun 27th
Very Cool Robot Jumper, It can jump up stairs, seem to be very powerful, very creative indeed Source: botjunkie.com
AnotherTricopter Video from W.Thielicke
Jun 27th
Another showing DIY tri-rotor helicopter W.Thielicke He done a great job! the building log available as PDF and the little a bit tricopter specs below.
Controller: Atmega32 @ 16 MHz
Gyroscopes (pitch, roll): ADXRS610
Gyroscopes (Yaw): Murata ENC-03R
Accelerometer ADXL322
Receiver: ACT DSL-4ST
ESC: Tower Pro n18A with I2C Modify
Motors: Scorpoin S2212-26
Propellers: EPP 10×45″
Battery: Kokam 3s, 3200 mAh
Frame: CFK coated plywood + CFk tube + Delrin (POM) hubs & spacers
Serial Data Link : Xbee Series 2
Endurance: 14 minutes
Source : diydrone
$87 DIY CNC Machine Made Out of Wood
Jun 22nd
3 axis CNC machine that made up from wood all it cost is only $87 as he showing the parts & materials bill, using stepper motors as actuator, great tolerant can mill plastic, PCB layout or even metal the spindle can run up to 20,000 rpm. The machine drawing blueprint can be found on the project page.
DIY Mini CNC Machine Under $100
Jun 20th
The project from letsmakerobots showing how to build low cost version CNC machine with Arduino controller, they were using simple woods housing, 7.5 degree/step stepper motor. G-code serial command from PC side sending to Arduino and from Arduino using I2C protocol communication to each axes stepper motor controller with ATtiny. all instructions and detrail can be found at: letsmakerobots
The Plays Pool Robot
Jun 18th
The PR2 Robot plays pool game! The “Poolshark” team developer slowing self thinking robots with ball tracking, table localization and more. source
QuadCopter UAV Image Processing 3D Mapping Guidance
Jun 16th
Parrot AR-Drone Quadcopter UAV on the video slow how do it learning from the first time manual guide then it recognize object from on-board camera with image processing algorithms building the 3D map and autonomous flight from recent relevant map, as they said it will be accurate than normal GPS guidance. via diydrones
DIY Simple pulse Jet from jam jar
May 29th
Do it yourself pulse jet from jam jar, simple materials that can find from your kitchen, with difference temperature the jet will running until the fuel burn out. build your own one and have fun with it !
